Technology

Technology

How to replace brake discs – step by step

16 November 2026Technology 4 min read

Brake discs are wear parts. At the latest when the minimum thickness is reached, a pronounced lip has formed or the brakes judder when slowing down, it is time to replace them. In the video we show the complete process on the front axle – here are the steps to read along.

Removal: wheel, caliper, pads, disc

  1. 01Remove the wheel. First lift the vehicle safely on a lift or axle stands.
  2. 02Unplug the wear sensor.
  3. 03Undo the caliper bolts.
  4. 04Remove the caliper. Important: do not let the caliper hang by its brake hose – set it down or tie it up.
  5. 05Take out the old brake pads.
  6. 06Unbolt the caliper bracket.
  7. 07Remove the disc retaining screw.
  8. 08Take off the old disc. If it is stuck, free it with a rubber mallet.
  9. 09Clean the wheel hub thoroughly. Even small traces of rust on the contact face will make the new disc run out and vibrate.

Fitting: new disc, pads, caliper

  1. 10Fit the new brake disc and secure it with the retaining screw. Always replace discs in axle pairs – left and right together.
  2. 11Degrease the new disc: remove the protective oil and preservative from the friction surface with brake cleaner.
  3. 12Refit the caliper bracket and tighten the bolts to the torque specified by the vehicle manufacturer.
  4. 13Install the new brake pads.
  5. 14Refit the caliper. Clean and grease the guide pins.
  6. 15Reconnect the wear sensor.
  7. 16Refit the wheel and tighten the wheel bolts to the specified torque.

After fitting

  • Before the first drive, press the brake pedal several times until it feels firm.
  • Avoid hard braking for the first 200 km – discs and pads need to bed in.
  • Always fit new pads together with new discs.

„Most problems after a disc replacement are not caused by the disc but by a poorly cleaned wheel hub.“

Work on the braking system is safety-critical and belongs in the hands of trained professionals. Torque values and minimum dimensions are given in the vehicle manufacturer's specifications. RK-Austria brake discs and pads are tested to ECE R90 and available to wholesalers and importers from stock in Austria.

Share